The Manufacturing Process

The Manufacturing Process

Mining and washing

  Drops or blocks of Baltic amber are mined from open pits of 40-60 million-year-old glauconite sand. Glauconite is a hydrated potassium-iron silicate mineral and these deposits are called "blue earth" because of their blue-green color. After the surface has been cleared, the blue earth is dug out with steam shovels and dredges. It is poured through grates at a washing plant, where streams of water are used to separate the amber from the sand. In the early twentieth century, up to one million lb (450,000 kg) of amber per year were extracted from the blue earth layer of the Samland Peninsula in the eastern Baltic.

amber manufacturing

Claryfying and coloring

   Large trapped air bubbles result in a foamy or frothy type of amber. Microscopic bubbles result in bony or osseous amber that looks like dried bone. Very cloudy amber is called bastard. Amber is clarified by heating in rapeseed oil. The oil penetrates bubbles near the surface and reduces the cloudiness, making even bony or bastard amber more transparent. Amber also may be clarified by heating under pressure with nitrogen and then baking in an oven. Clarification darkens the amber and produces disc-like stress marks, called "sun spangles." Amber may be stained green or reddish.

Cutting and reshaping

  For jewelry or carving, amber usually is worked by hand, with a jeweler's saw and fine-toothed files. It is wet-sanded with 320-grit cloth and finished with a 400- or 600-grit wet-sanding cloth. It can be drilled with dry steel drills, using a low speed and slight pressure, to prevent heating and cracking.

  To obtain a clear view of inclusions, one end of an amber piece may be chipped off. Amber with inclusions may be cut or reshaped for examination of the biological specimen or to separate two specimens. Cutting is done with a jeweler's hand saw or, for larger pieces, with a high-speed trim saw with a diamond blade, at speeds up to 4,200 rpm.

  Reshaping is done with various grades of sandpaper. Rough edges from the saw blade may be smoothed with 200- and 400-grit paper, by hand or with a belt sander equipped with a water cooling system, to remove dust and prevent overheating and fracturing or glazing.

Polishing

  Amber for jewelry is polished with tin oxide or cerium oxide, using a leather buff, Jelt wheel or pad, or chamois board. Periodic polishing with a silicone-based wax restores shine and decreases evaporation and surface oxidation.  

Making a Jewelry

  Because of amber value and fragility, almost all amber jewelry is handmade. After the polishing proceedure the gemstone goes to amber artists hands where the jewelry, carving or a home decoration is born. Each piece of article is exclusive, because each piece of Amber is unique.  

Posted on 04/13/2017 0

Leave a CommentLeave a Reply

You must be logged in to post a comment.

Blog archives

Latest Comments

No comments

Blog search

Recently Viewed

No products

Menu

Compare 0